WINDSHIELD RESTORE MARKETING -- WHAT WORKS, WHAT ISN'T REALLY

Windshield Restore Marketing -- What Works, What Isn't Really

Windshield Restore Marketing -- What Works, What Isn't Really

Blog Article

I have to be honest with you. I wasn't going to share this one. It was just too good. What if I let this cat out of the bag and everybody and their grandmother started cashing in on it? What then? But then I figured, what the hell? It's not like I do a lot of work these days and spend a lot of time on this one. Sure, I intend to dabble a bit, but full time? No way in hell. I'd much rather be playing video games and Magic the Gathering. So for the rest of us working stiffs, this one's for you.

4) You will need to have on hand fast tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.

With a putty knife, carefully scrape the remaining parts of the wax ring from the area. Clean the spot so that the new wax ring will be level. Place a new wax ring on the opening and replace the toilet. Bolt it back onto the floor, reconnect the water line repair supply tube and watch for leaks as the water is turned back on.



After you have the stems out you should be able to find the washer on the "inside" end. If it is nicked, torn or brittle it is likely the cause of your drip. Even if it looks brand new, go ahead and replace it. You've already come this far. You can get replacement washers at almost any hardware store. Sometimes you may want to replace the whole stem, especially if the handle end is stripped out. It's best to just take the stem with you to the store and see if you can match it up. Most Do It Yourself stores have replacement stems for many popular brands. If your valve has a center diverter valve to switch the waterfrom the tub spout to the shower head the same process applies. Many times it is easier to replace the diverter stem than to repair it. This really depends on the design of the stem.

Clean the hole in the gutter railing first. It must be free of any debris, so you may want to clean the entire drain channel using a proper cleaner. In this way, you will have a clean surface area which will allow you to repair the hole more easily.

Plumbers, like all other companies, are required to be on time and act professional. If they have called before hand to notify you then, this can be overlooked. However, if they turn up without apologising for being late, then they may not be the right plumber for you. Remember first water line repair impressions are everything. If they lack a good first impression then this may indicate that it is going to have an impression on their work. In most cases, you would have taken the time off work for the plumber, and what can be worse than waiting all day waiting for them to arrive?

68. Sea sickness: I always keep a bucket in the cockpit, much better that the sufferer is sick into a receptacle of sorts than tries to be sick over the side.

A large plumbing job, such as re-piping or installing additional fixtures, may require a permit. Check with your city's department of building and safety before asking for estimates, and avoid any plumbers who are reluctant to comply with regulations.

Report this page